Yes! We opted for MDF as a good basic table
that is flat and very inexpensive to replace. It just
bolts to the upper surface of the machine base.
As is the case with many routing operations, the
cutter may extend through the workpiece into the
table’s surface. It is because of this that most
users prefer to attach an inexpensive table
surface as a spoil board to be thrown away when
used up.
that is flat and very inexpensive to replace. It just
bolts to the upper surface of the machine base.
As is the case with many routing operations, the
cutter may extend through the workpiece into the
table’s surface. It is because of this that most
users prefer to attach an inexpensive table
surface as a spoil board to be thrown away when
used up.
